Makita DUR361U Manual De Instrucciones página 12

1
2
014835
Align the protrusions on the protector attachment with
the grooves of the protector.
1
014836
Align the protrusions on the protector holder attachment
with the groove of the protector holder.
1
014759
After attaching the protector and the protector holder,
tighten the hex bolts securely.
Installing the cutter blade
WARNING:
The outside diameter of the cutter blade must
•
be 230 mm. Never use any blade exceeding 230
mm in outside diameter.
CAUTION:
The cutter blade must be well polished, free of
•
cracks or breakage. Polish or replace the cutter
blade every three hours of operation.
Always wear gloves when handling the cutter
•
blade.
Always attach the blade cover when the tool is not
•
in use or is being transported.
The cutter blade-fastening nut (with spring
•
washer) wears out in course of time. If there
appears any wear or deformation on the spring
washer, replace the nut. Ask your local authorized
service center to order it.
1. Protrusion
2. Groove
1. Protrusion
2. Groove
2
1. Hex wrench
2. Hex bolts
2
NOTICE:
Be sure to use genuine Makita cutter blade.
•
Turn the tool upside down so that you can replace the
cutter blade easily.
1
2
3
014766
To dismount the cutter blade, insert the hex wrench
through the hole on the protector cover and the gear
case. Rotate the receive washer until it is locked with
the hex wrench. Loosen the hex nut (left-hand thread)
with the socket wrench and remove the nut, clamp
washer and hex wrench.
2
1
014767
Mount the cutter blade onto the shaft so that the guide
of the receive washer fits in the arbor hole in the cutter
blade. Install the clamp washer and secure the cutter
blade with the hex nut with 13 to 23 Nm of tightening
torque during holding the receive washer with hex
wrench.
014768
Make sure that the blade is the left way up.
12
1. Hex nut
2. Clamp washer
3. Cutter blade
4
4. Receive washer
5
5. Hex wrench
1. Hex wrench
2. Box driver