Measuring Body Temperature - Medisana FTN Instrucciones De Manejo

This is how to do it:
1. Switch on the device using the ON/OFF button
selector switch
mode (top /
a corresponding flashing symbol,
and (anus).
2. Wait until the °C symbol flashes, indicating that the
thermometer is ready.
3. Move the switch
of the reference part of the body are shown in the display for
approx. 3 seconds. The set symbol flashes, while the other
ones remain unchanged.
4. Press the START button
symbols within the 3 seconds. As soon as the change is
registered, you will hear a short beep.
5. The selected symbol flashes. The setting is completed after 5
seconds and the thermometer is ready for the measurement.

3.2 Measuring body temperature

NOTES
For the most accurate readings:
• The thermometer and the patient must remain in a
stable environment for at least 30 minutes before
measuring the temperature.
• Do not take a baby's temperature during or directly
after breastfeeding.
• Do not use the thermometer in damp environments.
• Patients should not drink or eat directly before or
during a measurement, and they should avoid any
physical exertion.
• Clean the area where you are taking the temperature
and remove any dirt, hairs or sweat before moving the
sensor
• Do not remove the thermometer from the measuring
position until it has beeped to signal the end of the
reading.
• If the sensor
clean it with a cotton bud dipped in cleaning alcohol
before putting the thermometer away.
• Always take the temperature in the same place, because
the readings will vary in different environments.
is in the fever measurement position / body
). The set reference location is displayed by
down and then up again. The 3 symbols
to the measuring position.
becomes dirty during or after a reading,
3 Operation
(mouth),
to switch between the three
Continued —>
GB
. The
(armpit)
21