Descargar Imprimir esta página

Bosch PA0840M Instrucciones De Uso página 37

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 70
Dehumidification in continuous mode:
• Place a receptacle at the end of the water
drainage pipe to collect the condensed
water or lead the pipe to the nearest drain.
• Remove the plug from the water drainage
pipe on the back at the bottom of the unit.
The appliance does not stop working in this
mode. It does not beep or display the
symbol
when the external receptacle is
full.
• Select the dehumidification function
"Selecting the operation function").
• Select the operation speed, (see "Selecting
the speed").
Warnings
The amount of water dehumidified may
vary depending on ambient conditions
(See "Technical Information").
When the appliance is operating in the
dehumidification function, the temperature
does not appear on the screen and cannot
be selected or modified.
Warning!
Do not forget to replace the plug onto the
water drainage pipe when you change
function, otherwise the appliance will shed
water when operated.
Remember that ambient temperature must
be 18°C or higher in order for the appliance
to work.
The appliance expels hot air through the
drainage pipe when operating in the
dehumidification function. This is
necessary for the appliance to work more
efficiently in this operation function.
Air purification
The air inside the room (ventilation) is
circulated through a purifying filter (air
purification) when the appliance is set to this
function.
The appliance comes with a basic filter
(already fitted on the appliance) and a double
active filter to be fitted by the user, see "Fitting
the purifying filter (double active)", against:
Instructions for Use
- Smells and smoke.
- Pollen, bacteria and dust.
❏ Plug the appliance into the mains electricity
supply.
❏ Fit the hot air expulsion tube (see
"Preparing the appliance before use").
❏ Lift the air director on the top of the
appliance.
❏ Select the air purification function
"Selecting the operation function").
(see
❏ Select the operation speed, (see "Selecting
the speed").
Warning
We recommend you leave the filters in
position regardless of the function setting
(air conditioning, dehumidification, air
purification) in order to purify the air more
effectively.
Ionisation
Your air-conditioning system is fitted with an
ioniser which can be connected additionally.
The ioniser enriches the air with negatively
charged ions. In nature, this normally happens
after a summer storm, on the coast or in
mountain areas. Ionised air is fresh and clean
because it is exceptionally rich in negative
ions
• Press the ioniser key
panel to activate the ioniser. The ion symbol
appears on the screen and the appliance
beeps to indicate that the function has been
activated.
• Press the ioniser key again to deactivate it.
The ioniser symbol disappears from the
screen and the appliance beeps.
Selecting the temperature
This function is only available in the cooling
function.
Place the selection box on the temperature
selection menu (see "up" and "down" keys).
Use the "+" and "–" keys to move within the
selection box until the desired temperature is
reached (see "+" and "–" keys).
37
, (see
on the control

Publicidad

loading