Remington PG6070 Manual página 4

ENGLISH
, VACUUM FEATURE
• The Vacuum technology captures virtually all the facial hair
as it is cut. The hairs are vacuumed into an easy empty
vacuum chamber located on the front of the beard trimmer.
It is recommended that you empty the vacuum chamber
after each use by sliding out the section away from the
beard trimmer (Fig. A).
C GETTING STARTED
, CHARGING YOUR APPLIANCE
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
• Before using your beard and grooming kit for the first time, charge the unit
for 4-6 hours for optimal performance. Typical charge time will be 4 hours
thereafter.
• When charging the LED charge indicator will turn blue. The blue light will turn
off after charging is complete.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 4 hours.
• This appliance should be charged by approved safety isolating adaptors
PA-0510E (for EU version) or PA-0510U (for UK version) with the output
capacity of 5.0V dc; 1A;
, CORDLESS USE
• Please note that this product is cordless use only and cannot be used when
connected to the mains.
• When the unit is switched on and fully charged, the product can be used in
cordless mode for up to 60 minutes.
, WARNING: Keep the appliance dry.
F INSTRUCTIONS FOR USE
, TO ATTACH / REMOVE ATTACHMENT HEADS
• Select attachment head that best fits your grooming needs.
• Place attachment head on top of the unit. Secure carefully until the
attachment head clicks into place.
• To remove attachment head press the head release buttons on the side of the
head and pull the attachment head away from the unit body.
• Slide On/Off Switch upward to power the beard trimmer.
4
Fig. A