Worx WX439 Manual De Instrucciones página 15

it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
WARNING:
Do not release the handle until the saw blade
come to complete stop and do not touch saw blade
while the saw blade is running.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
Action
Mounting and Removing the Blade
NOTE: Lock or loose the blade
bolt, the spindle lock button
should be pressed.
WARNING: Always
remove the battery before
changing the blade!
Compact Circular Saw
Safety switch and On/Off trigger
sharp blade, please don't put
your hands around the Base
Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Rip and Cross Cutting
NOTE: The cutting line of saw
blade is aligned with the cutting
mark 0°.
Parallel Guide
Adjusting the Cutting Depth
Adjusting the Cutting Angle
NOTE: The cutting line of saw
blade is aligned with the cutting
mark 45°.
Pocket /Plunge
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance
and cutting quality depend essentially on the
condition and the tooth count of the saw blade.
Therefore, use only sharp saw blades that are suited
for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Figure
Only use saw blades recommended.
MAINTAIN TOOLS WITH
See Fig. A
CARE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
WARNING: To avoid
cutting injury from the
See Fig. B
See Fig. C1, C2
See Fig. D1, D2
See Fig. E1, E2
See Fig. F
See Fig. G1, G2
See Fig. H
15
EN