YATO YT-82395 Manual Del Usuario página 11

PRODUCT OVERVIEW
Electric sheet metal shear is used for fast cutting of steel and aluminium sheets. Cutting is done with two blades, one moving in a
reciprocating motion inside the head and the other fi xed in the head. Both straight and curved cutting is possible. Proper, reliable
and safe operation of the power tool depends on appropriate use, that is why you should:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
PRODUCT ACCESSORIES
The tool comes complete but requires some assembly work. Two movable blades are supplied with the tool.
TECHNICAL DATA
Parameter
Part no.
Mains voltage
Mains frequency
Rated power
Cutting frequency
Maximum cutting thickness
carbon steel
Stainless steel
aluminium
Weight
Noise level
- sound pressure L ± K
pA pA
- power L ± K
wA wA
Vibration level ± K
ah,AG
Insulation class
Protection rating
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Note! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is used.
Note! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of use (in-
cluding all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
O R I G I N A L
EN
Unit
[V~]
[Hz]
[W]
[min ]
-1
[mm]
[mm]
[mm]
[mm]
[kg]
[dB (A)]
[dB (A)]
[m/s ]
2
I N S T R U C T I O N S
Value
YT-82395
230 – 240
50
600
2000
215
1.8
1.2
2.5
2.0
88,0 ± 3.0
99,0 ± 3.0
11,57 ± 1.5
II
IPX0
11