Publicidad
1. Light switch "LIGHTS"
2. Engine stop switch "ENG. STOP"
3. Start switch "START"
4. Horn switch "
"
1. Contacteur d'éclairage "LIGHTS"
2. Coupe-circuit du moteur "ENG. STOP"
3. Contacteur du démarreur "START"
4. Contacteur de l'avertisseur "
1. Interruptor de luces "LIGHTS"
2. Interruptor de paro del motor "ENG. STOP"
3. Interruptor de arranque "START"
4. Interruptor de la bocina "
"
"
NOTE:
If the starter switch is pushed with the main switch
"ON" and the engine stop switch "OFF", the starter
motor will be activated but the engine will not start.
To start the engine, be sure to position the engine
stop switch at "RUN".
Light switch "LIGHTS"
Set the switch to the "LO" position to turn on the
low beam and the taillight.
Set the switch to the "HI" position to turn on the
high beam and the taillight.
Set the switch to the "OFF" position to turn off all of
the lights.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it.
_
4-7
EBU11560
Publicidad
