Publicidad
Idiomas disponibles
Idiomas disponibles
36
SPECIFICATION
Problem
Wrinkling
Power is not turned on
The door does not open
when the cycle pauses or
finishes
The wash cycle time is
longer than usual
It is musty or moldy in the
tub
SPECIFICATIONS
Model WM3050CW
Description
Electrical requirements
Dimensions
Net weight
Wash capacity
Max. Watt
Max. spin speed
Max. water pressure
Possible Causes
y Did you remove the load immediately after it
finished?
y Did you overload the tub?
y Did you reverse the hot and cold water inlets?
y Is the power cord plugged in properly?
y Has a house fuse blown, a circuit breaker
tripped, or a power outage occurred?
y Is the temperature in the tub too high?
y Is the water level in washer high?
y Is the washing machine overloaded? Are other
options added to the wash cycle?
y Has the incorrect detergent been used?
y Did you clean the tub periodically?
Front loading washing machine
120 V~, 60 Hz
686 mm(W)×767 mm(D)×982 mm(H)
88 kg (194 libras)
18.0 kg (40 libras)
1200 W
1200 rpm max.
100 – 1000 kPa (1.0-10.0 kgf/cm
y Remove the load immediately after it finishes.
y Do not overload the tub.
y Hot water rinse can cause garments to
wrinkle. Check the inlet hose connections.
y Make sure that the plug is secured in a
grounded 3-prong, 120 V (60 Hz) outlet.
y Reset the circuit breaker or replace the fuse.
Do not increase the fuse capacity. If the
problem is a circuit overload, have it corrected
by a qualified electrician.
y The washing machine has a safety lock built
into the door to prevent burning. Leave the
door closed and wait until the door lock icon
disappears from the display.
y Allow the washer to complete the
programmed cycle, or Press the SPIN button.
y This is normal. The washing machine
automatically adjusts the cycle time for the
amount of laundry, water pressure, water
temperature, and other operating conditions.
y See page 30, clean the inside and outside of
the washing machine periodically.
)
2
Solutions
Publicidad
