Sabo 92-13 H B Manual Del Operador página 53

UNPACKING AND ASSEMBLY
First connect the red wire (5) to the positive
pole (+) and then the black wire (6) to the neg-
ative pole (–), using the screws supplied as
shown.
Apply silicone grease to the terminals and
check that the protective cap for the red wire
(5) is in place.
Replace the battery in its housing making
sure that the two poles are facing the centre
of the machine, connect the elastic tie-rod (3)
and refit the guard (2).
IMPORTANT
device in the electronic circuit board from
cutting in, never start the engine until the
battery is fully charged!
To prevent the safety
4
6
1
3
11
EN
2
1
5