Sabo 92-13 H B Manual Del Operador página 62

20
EN
area! ALWAYS REMEMBER THAT EXHAUST GASES ARE TOXIC!
To start the engine:
– open the fuel stopcock (1) (
– shift in the gear into neutral («N») (
– disengage the blades (
– apply the parking brake on sloping ground;
– when starting from cold, move the throttle to the
«CHOKE» position shown on the label;
– if the engine is already warm, position the lever
between «SLOW» and «FAST»;
– put in the ignition key and turn to «ON» to make electri-
cal contact, then turn to «START» to start the engine;
– release the key once the engine has started.
When the engine has started, move the throttle to «SLOW».
IMPORTANT
smoothly. Using it when the engine is already warm can foul the spark plugs and
cause the engine to run erratically.
NOTE
running the battery flat and flooding the engine. Turn the key to «OFF», wait for a few
seconds and then repeat the operation. If the malfunction persists, refer to the
engine manual and chapter «7» in this manual.
IMPORTANT
from starting if safety requirements have not been met (
In these cases, once the situation has been corrected, the key must first be turned
back to «OFF» before the engine can be restarted.
5.4.2 Starting and moving without mowing
WARNING!
!
It has to be used (as indicated by the highway code) in private areas closed to
traffic.
When moving the machine, the blades must be disengaged and the cutting deck
raised as high as possible (position «7»).
if fitted);
4.7);
The choke must be closed as soon as the engine is running
If there are engine starting problems, do not insist as you can risk
Always bear in mind that the safety devices prevent the engine
This machine has not been approved for use on public roads.
4.22 or 4.32);
HOW TO USE THE MACHINE
1
5.2).