Orbegozo SP 6000 Manual De Instrucciones página 16

SP 6000
2. Press button, enter into fan mode and display shows "- -".
3. Press button once, the product Works with low heating (1000W) and display shows "- -/I". Press
again, changes to high heating (2000W) and display shows "- -/I/II".
4. Press button to set timer (1-12 hours). Pressing the button one time increases one hour for timer.
After setting time, the display will show current setting time for 5 seconds, then resume to previous
display, meanwhile the light of
5. "Turn on" timer: in standby mode, press
1-12 hours. After complete setting, the display shows the appointment turn on time and also the light
is on. The display automatically decreases 1 hour for each hour passed. When the appointment
power-on time arrived, the product will automatically turns on. The default setting temperature is 23ºC
during appointment turn-on. Below pictures is an example to set appointment turn on time to 8 hours:
will on. Below photo is an example of setting 8h:
timer button, you can set the appointment turn-on time in
16