Publicidad
SERVICE AND ADJUSTMENTS
•
ATTACH MOWER SIDE SUSPENSION ARMS (A) TO
CHASSIS - Position hole in arm over pin (B) on outside
of tractor chassis and secure with retainer spring.
•
Repeat on opposite side of tractor.
A
•
ATTACH REAR LIFT LINKS (C) - Lift rear corner of
mower and position slot in link assembly over pin (D)
on rear mower bracket and secure with washer and
retainer spring.
•
ATTACH FRONT LINK (E) - Work from left side of trac-
tor. Insert rod end of link assembly through front hole
in tractor front suspension bracket (F).
B
Fig. 21
C
D
Fig. 22
R
Q
P
•
Insert end of link (E) into hole in front mower bracket
and secure with washer and retainer spring (J).
•
Hook end of clutch cable spring (Q) into hole in idler
arm (R).
•
Push clutch cable housing guide (P) into bracket, slide
collar (L) onto guide and secure with retainer spring (K).
•
Install belt on engine pulley (M), in belt keepers (G).
IMPORTANT: CHECK BELT FOR PROPER ROUTING
IN ALL MOWER PULLEY GROOVES.
•
Raise attachment lift lever to highest position.
•
If necessary, adjust gauge wheels before op er at ing
mower as shown in the Operation section of this manual.
M
G
A
C
D
Fig. 25
19
E
J
F
Fig. 23
M
Fig. 24
F
G
E
B
H
Publicidad
