Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY TEST
1. Connect the black test lead to the "COM" jack and the red test lead to the
" INPUT " jack (Note: The polarity of the red test lead is positive "+").
2. According to the different type of the battery (1.5 V, 9 V,) to be tested,
set the range switch to the desired BATT range.
3. Connect the test leads to the battery to be tested.
4. Read the reading on the display. The polarity of the red test lead
connection will be indicated.
5. "
After pressing this button, the present reading is held on the display,
meanwhile "
" is displayed on the LCD as an indicator. To exit the Hold
Mode, press the button again and the indicator "
Pressing the button more then 2 seconds， back-light turned on， pressing
the button more then 2 seconds again or delay 15 seconds， the back-light
will turn off.
6. AUTO POWER OFF
If you don't operate the meter for about 15 minutes, it will auto power off
(Sleep mode).
In the power off state, press the "Select" button to power on. To cancel the
Auto Power Off function, press and hold "Select" button and turn on the
meter, the meter will "bi" 5 time and no "APO" symbol in LCD.
7. BATTERY & FUSE REPLACEMENT
Fuse rarely need replacement and blow almost always as a result of
operator error.
If "
" appears in display, it indicates that the battery should be replaced.
To replace Battery, remove the screws in the bottom of the battery case,
simply remove the old, and replace with a new one. Be careful to observe
polarity.
To replace Fuse, remove the hostel and remove the bottom cover of the
meter to replace the fuse. Please replace the appropriate fuse according
to operation manual.
" FUNCTION
Hold
" will disappear.
Publicidad
