To Drop Or Raise The Feed Dogs; Darning - Sears Kenmore 385.15212 Manual De Instrucciones

To Drop or Raise the Feed Dogs
Remove the extension table from the machine by pulling it
to the left. Open the shuttle cover by pulling down the
embossed part on the left of the cover.
$1_,
\/To drop the feed dogs, push down the lever out of the
notch, and shift the lever in the direction of the arrow as
illustrated.
_ To raise the feed dogs, push down the lever out of the
notch, shift the lever in the direction of the arrow as
illustrated, and then turn handwheel towards you.
Feed dogs must be up for normal sewing.
Darning
_!_ Stitch pattern selector:
_2_Presser foot:
_3_Needle thread tension:
_4_Stitch length control:
_5_. Stitch width control:
_6_Feed dogs
1 or2
Removed
1 to4
Any
_:3 (0) or _ (5)
Dropped
Drop the feed dogs (see above) and remove the presser
foot. Center the hole in the fabric on an embroidery hoop,
as shown. Lower the presser bar and sew at a slow speed.
Move the fabric back and forth slowly until the darning area
is covered. Turn the fabric a 1/4 turn (90°), and sew
another layer of stitching over the first layer.
NOTE:
If the fabric is thin or badly damaged, use a separate
piece of fabric under the hole to reinforce it.
f
f
/\
{_jJ
i i
,#i_kA
m ,#Ulna m
I\ j,_
l i • •
STRETCH
S V L--0_1_21314
_0--1--2--3--4--5_
,\
\kk\
f,,_,
_6_,
i
J
i
AAA
J
40