Section Ii, Getting Readyto Sew Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety; Polarized Plug - Sears Kenmore 385.15212 Manual De Instrucciones

SECTION II. GETTING READYTO SEW
Connecting Machine to Power Supply
_1_Power supply plug
_2_Power switch
_3_Outlet
_4_Machine socket
_5_Machine plug
_6_Sewing light
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch _2_.
2. Insert the machine plug_5_ into the machine socket (4_.
3. Insert the power supply plug (1)into the outlet _3_.
4. Turn on the power switch_2_ to activate the power and
sewing light _6_'.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts, such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended
- When attaching or removing any parts
- When cleaning the machine
* Do not place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of an electric shock, this plug
is intended to fit in a polarized outlet only one way. If the
plug does not fit in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J or TJC-150 is used with
Sewing Machine Model 385.15212, 385.15218, 385.15616
and 385.15718.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
/
J