Tabla de contenido
Publicidad
To
Drop
or Raise
the Feed
Dogs
The drop feed dogs lever is located underneath the free
arm bed on the back side of the machine.
To drop the feed dogs, push the lever in the direction
of the arrow as illustrated.
To raise the feed dogs, push the lever in the direction
of the arrow as illustrated and turn the handwheel toward
you. Feed dogs must be up for normal sewing.
S
Darning
_1_ Stitch selector:
6 to 8
Stitch width:
6.5
Stitch length:
Any
Needle thread tension:
2 to 6
Pressure adjusting lever:
O
Presser foot A:
Zigzag foot
_t_Presser foot F:
Satin stitch foot
Feed dogs:
Dropped
Drop the feed dogs. Place fabric, with the hole in the center,
on an embroidery hoop, as shown.
Lower the presser foot F and sew at slow speed.
Move the fabric back and forth slowly until the darning area
is covered. Turn the fabric 1/4 turn (90 °) and sew another
layer of stitching over the first layer. After darning is
completed, return the pressure adjusting lever to 3 for
normal sewing.
NOTE:
If fabric is thin or badly damaged, use a separate piece of
fabric under the hole to reinforce it.
_)
_
WIDTH
I
I
I
I
I
I
I
]
]
_
LENGTH
,iD cp c I,
®
®
o°r
®
®
\
J
J
/
46
Publicidad
Tabla de contenido
