INVENTOR KRM-12L Manual De Usuario página 19

7. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you
have switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit
and the display will read P2. Additionally, when the unit is on and the tank is full, the
compressor stops operation followed by the fan a few minutes later. The full indicator
will flash and the display will show P2.
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards
so the water does not overflow. Do not place the tank on the floor because the bottom
of the tank is uneven. Doing so the tank will fall and the water will be spilled on the
floor.
• Empty the water from the tank and place it again in to the device. The water tank,
must be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
EN
Note:
• When Auto Defrost is operating, the unit
may cause some noise of the refrigerant fluids
flowing, this is normal.
• Do not turn the dehumidifier off when auto
defrost is operating.
• If the Αuto defrost indicator light flashes,
unplug the unit and plug it back in. If error
repeats, call for service.
• When you remove the tank, do not touch any parts
inside the unit, as you may damage the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the
device.
• Wipe any excess water on or in the unit when removing
the tank.
19