Sagola PSAM 104 Manual De Instrucciones página 10

HOW TO USE THE GUN SAFETY
In order to engage the safety (block the opening in the trigger
1
of the gun), move the trigger forward (locked position) and
turn the lever (no. 1 - gure 2) until it butts against the gun
body. Check that the trigger is locked.
In order to disengage the gun safety, push the trigger forward
2
(closed position) and turn the lever (no. 1 - gure 2) until it
butts against the trigger itself.
HOW TO USE THE GUN
Connect a uid hose (with grounding wire) to the gun inlet.
1
Without installing the tip, start up the pump.
2
Remove the product used for cleaning the pump. Prime the
3
unit with the product and apply to pump as indicated in the
instruction manual.
Unthread the guard and nut.
4
Place the spray tip and locking seal together with the nut and
5
guard. Tighten rmly.
Start up the pump. Adjust the pressure until the uid comes
6
out completely in the form of a spray. Use the least pressure
necessary. A higher pressure will cause excessive wear in the
material and premature wear of the tip and locking seat. If
you need higher product ow, take a tip with a larger tip. If
it is not possible to spray the product correctly, use a smaller
size tip until the correct size is determined for the required
coat thickness and optimum spraying conditions.
Pull the trigger in such a way that it is completely open or
7
completely closed. Keep the gun at a distance of 200-300
milimetres from the working surface. Move the gun
perpendicularly to the surface at the appropiate speed,
overlapping paint strokes.
INSTALLATION AND OPERATION
FIGURE 2
ADJUSTING THE SPRAY JET
In order to adjust the spray jet correctly, do the following:
1
Follow the decompression procedure described on page 11.
2 Loosen the tip support nut ( gure 3). Turn the tip guard and
place the groove in the horizontal position in order to obtain
a vertical fan.
ACCESSORIES SUPPLIED WITH THE GUN
Filter 100 mesh (yellow)
Multiple gun wrench
Hexagonal female wrench
10
FIGURE 3