Operating Hand Tool - Tennant EX-CAN-15-HPH Manual Del Operario

OPERATION
EN
NOTE: For heavily soiled areas, repeat stroke or
change angle of stroke.
4. Check for excessive foam buildup in recovery tank.
Use a recommended foam control solution to
prevent vacuum motor damage.
ATTENTION: Excessive foam buildup will not
activate the float shut-off screen. Vacuum motor
damage may result.
5. When finished cleaning, turn off switches and drain
recovery tank (See DRAINING RECOVERY
TANK).
6. After cleaning, relieve water pressure from floor
tool before disconnecting hose. Squeeze trigger for
five seconds after turning off the machine

OPERATING HAND TOOL

Optional accessory tool is required.
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
NOTE: This machine cleans most synthetic upholstery
very well. Fabrics like Herculon and synthetic velvets
will clean with excellent results. Extraction is not
recommended for most cottons, silks, wools or natural
fiber velvets. Check cleaning instructions sewn in
furniture by manufacturer for further instructions. Extra
caution should be taken with furniture that has been
re-upholstered. Any material under new upholstery may
bleed and discolor new fabric.
NOTE: Vacuum upholstery before cleaning.
1. TEST FABRIC FOR COLORFASTNESS: Pour a
small amount of cleaning solution on a white cloth.
Hold damp portion of cloth against an area of
upholstery which is hidden from view. Hold it there
for 60 seconds. If no color transfers to cloth, it
should be safe to clean. However, always use your
best judgement.
ATTENTION: Be certain the circuit indicator light is
on to verify that two separate circuits are being
used.
8
Home Find... Go To..
2. Activate vacuum, pump and heater switches.
3. Adjust pressure valve knob to read 30 psi on
pressure gauge (Figure 8).
FIG. 8
4. Place hand tool on fabric and squeeze trigger while
applying pressure on fabric and slowly pull tool
backwards. Be careful not to over wet upholstery.
Repeat stroke without spray to get fabric as dry as
possible. Overlap cleaning strokes to avoid
streaking (Figure 9).
FIG. 9
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
ATTENTION: Do not allow water or foam to enter
float shut- -off screen in recovery tank.
5. When finished cleaning, turn off switches and drain
recovery tank (See DRAINING RECOVERY
TANK).
6. After cleaning, relieve water pressure from
accessory tool before disconnecting hose.
Squeeze trigger for five seconds after turning off
the machine.
EX- -CAN- -15- -HPH (04- -10)