WERTAIR Mamba Pro Manual De Instrucciones página 17

The installation must be performed only by trained or skilled operators.
Take the compressor out of its package and check that no damages occurred during
transport; then assemble the provided silent-feet (when required) (fig.1).
Install the compressor in a suitably sized room, well ventilated and not wet (relative hu-
midity less than 75%), where the temperature is between +5°C and +40°C.
Place the compressor on a flat surface, able to support this device weight.
When this compressor is not placed on a floor, be sure that the frame supporting the
compressor is properly sized to carry on the compressor weight and is steady to the di-
namic stresses caused by its running.
In case of poor ventilation, install a suitably sized exhauster or fan.
Avoid to place the compressor close to walls or furnitures; leave a free
space of almost 50 cm around the unit in order to ensure an adequate venti-
lation.
INSTALLATION
3
3.1 - GENERAL INFORMATION
GB
16