Publicidad
Idiomas disponibles
Idiomas disponibles
3.6.18. Calibrating the ORP probe
1) Open the ORP 475 mV calibration solution.
2) Turn off the filtration (and therefore the electronics unit).
3) If the probe is already installed :
a) Remove the probe from the probe holder, without disconnecting it.
b) Remove the probe holder nut and replace it with the stopper supplied.
If the probe is not already installed :
Connect the probe to the electronics unit.
4) Turn on the electronics unit.
5) Go to the «
6) Navigate through the menus following the instructions below :
OK
OK
(Wait a few seconds)
or
3.6.19. Activation/deactivation of pH regulation
Menu
3.6.20. Manual injection
Menu
Priming
peristaltic
and filling of semi-
rigid pipes.
pH
injection.
Means of checking
the
operation of the
peristaltic pump.
» menu.
Insert the probe into the ORP calibration solution, then wait a few minutes.
Do not touch the probe.
a) Rinse the probe under running water, then leave to drip-dry it without wiping it.
b) Install the probe into the probe holder.
Carry out the navigation again with the above instructions, several times if necessary.
If calibration still fails, replace the probe and carry out another calibration.
Possible settings
ON
OFF
Functions
Possible settings
of
the
pump
From 30 seconds
to 10 minutes, in
corrector
increments of 30
seconds.
correct
Default setting
Default setting
To start injecting :
Confirm the duration setting.
(The peristaltic pump is running,
and a timer countdown is
displayed in real time.)
1 min
To take a break, and to restart
the injection :
Press on OK.
To stop the injection :
Press on
ON
Instructions
.
12
Publicidad
