Publicidad
Idiomas disponibles
Idiomas disponibles
IMMEDIATE
MESSAGE
AUTOMATIC ACTION
DISPLAYED /
FAULT
Stopping
DETECTED
production
Yes
Yes
No
No
Yes
Yes
CAUSE
Stopping
pH
regulation
Insufficient water flow
Yes
through
circuit.
Loss of communication
between
No
board and the power
board of the electronics
unit.
pH
probe
No
calibrated.
Series of 5 unsuccessful
Yes
attempts to correct the
pH.
Insufficient amount of
Yes
water in the filtration
circuit.
ORP measurement out of
tolerance for 48 hours
No
(difference of ± 400 mV
compared to the ORP
setpoint).
CHECKS AND REMEDIES
Check that :
the flow sensor is connected
to the electronics unit.
the flow sensor is activated
(«
menu).
the valves on the filtration
the
filtration
circuit are open.
the
working correctly.
the filtration circuit is not
blocked.
there is enough water in the
pool.
the
control
Contact a professional.
incorrectly
Carry out a calibration of the
pH probe.
Ensure the pH corrector
container is not empty.
Carry out a manual injection
(menu «
Check the condition of the
filter
injection connector.
Check the settings in the
«
«
and «
menus.
Carry out a calibration of the
pH probe.
Check that the filtration pump
is running correctly.
Carry out a «
Carry out a calibration of the
ORP probe.
Go to the «
that the production setpoint
is at 100 %.
»
filtration
pump
is
»).
with
ballast
and
»,
»
»
».
» menu and check
OPTION TO
DEACTIVATE
VIA THE
MENU
«
»
No
No
Yes
Yes
Yes
Yes
15
Publicidad
