Publicidad
Idiomas disponibles
Idiomas disponibles
3.4.4. TROUBLESHOOTING:
Problem
The engine will not start
The engine runs unevenly
Engine overheats
Poor cutting performance
Excessive vibration
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal household waste but should
be taken to a collection point for the recycling of electrical and electronic equipment. This is indicated by
the symbol on the product, operating instructions, or packaging. The materials used in this appliance are
recyclable according to their marking. By reusing, recycling, or applying other forms of use of waste
machines, you make a significant contribution to the protection of our environment.
Your local administration will provide you with information about the appropriate disposal point for used
appliances.
Possible cause
1. The engine on/off switch is in the
off position.
2. The spark plug wire is
disconnected
3. 3. No fuel or used fuel
4. Clogged fuel line
5. Dirty spark plug
6. Flooding the engine
7. Too little oil in the engine
1. Spark plug wire is loose
2. Clogged fuel line or old fuel
3. Air vent clogged
4. Water or dirt in the fuel system
5. Dirty air filter
1. Low engine oil level
2. Dirty air filter
3. Limited air flow
1. The trimmer line is too short or
worn out.
2. Worn or damaged belt
1. Lines are uneven or damaged.
2. Mower head bolts are loose.
3. Loose nuts or bolts.
4. Cracked mower head.
Action
1. Set the switch to the ON position.
2. Connect the spark plug wire to the
spark plug
3. Fill with clean, fresh gasoline
4. Clean the fuel line
5. Clean, adjust the gap or replace it
6. Wait a few minutes to restart the
engine
7. Add more oil to the engine
1. Connect and tighten the spark plug
wire
2. Clean the fuel line. Fill the tank with
clean, fresh gasoline
3. Clean the air vent
4. Drain the fuel tank. Refill with fresh
fuel
5. Clean or replace the air filter
1. Fill the crankcase with the correct
oil
2. Clean the air filter
3. Remove the cover and clean it
1. Replace the trimmer cord.
2. Replace the belt
1. Adjust or replace the cables.
2. Tighten the screws.
3. Inspect all bolts and nuts, including
engine bolts.
4. Replace the damaged part.
Publicidad
