Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Setting the inclination angle
The fan's inclination angle can be manually adjusted by up to 90°.
Move the fan head forwards or backwards. Make sure that the fan head locks
into the desired inclination angle.
Adjusting the height
The height of the fan can be adjusted from 89 cm to 110 cm.
1. Press the button on the stand and move the fan head upwards.
2. Release the button at the desired height.
Carefully move the fan head down or up to gradually adjust the stand to the
desired height. Make sure that the stand locks into place at the desired height.
CLEANING AND CARE
WARNING! Electric voltage:
nect the mains plug from the socket before cleaning.
- Never immerse the appliance in water for cleaning, which could cause
serious injury or fire.
IMPORTANT:
stances will damage the plastic parts and are flammable.
Clean the outside of the device with a dry cloth, without any additives. Keep the
air vents free of dust and dirt.
If the device is very dirty, you can also dampen the cloth slightly. Then wipe the
device with a dry cloth.
Changing the battery of the remote control
Replace the battery, type CR2032, if necessary.
Make sure that the insertion direction is correct (plus
pole upwards).
Note
Observe the information in the chapter Disposal.
STORAGE
WARNING! Electric voltage:
for a longer period of time must be checked by a qualified electrician before
being put into operation again in order to avoid hazards.
Store the appliance in a dry, frost-free room. Avoid direct sunlight.
- Remove the power adapter and wind up the power cord.
- Store the device and power adapter in a dust-protected and safe place.
14
Do not use solvents such as petrol, alcohol, etc. Such sub-
Always switch off the device and discon-
Devices that have not been in operation
Publicidad
