1. GENERAL INFORMATION
WARNING: Pease read and understand perfectly the present instruction before using the machine.
This manual provides you with the necessary instructions to start, use, maintain and in your case, repair of the pre-
sent machine. All aspects as far as the safety and health of the users is concerned have been stated. Respecting all
instructions and recommendations guarantees safety and low maintenance. As such, reading this manual carefully is
compulsory for any person responsible for the use, maintenance or repair of this machine.
2. GENERAL DESCRIPTION
ATA 450 and 580, have been designed and manufactured to be used in work sites in tying re-bar and lat bars for cons-
truction. The machine has an ergonomic design, which gives the operator the possibility to simplify the work getting a
high eficiency operation.
•
The automatic rebar tying machines is a hand-help in tying bars quickly.
•
The machine has an ergonomic design, which gives the operator the possibility to simplify the work getting a high
eficiency operation.
•
Low maintenance.
•
The machine consists of a main body, a spool of wire, battery charger and an extra battery.
•
The machine is driven by an electric motor powered by battery. This turns the reel and a small rotor that binds the
wire.
Incorporates the most advanced technology for power tools, which we are pleased to conirm that it has acquired
•
a useful and easy to use machine.
3. SECURITY INSTRUCTIONS
To avoid serious injuries to persons or property, please read these safety instructions carefully and
make sure you understand them.
Using the RE-BAR tier for other purposes or other applications than described in this manual can re-
sult in serious accidents. Please make sure that you follow all instructions in the manual.
Use appropriate protection gear.
Employer and operator must make sure that the operator
uses proper eye protection when the tool is used. This
protection must comply with current laws and norms.
Ear protection can be necessary.
On a lot of work sites, it can be necessary to wear ear
protection, to avoid permanent damage to the ears. Em-
ployers and employees must make sure that proper ear
protection can be found and is used on the
work site.
No children near the RE-BAR tier.
Do not allow spectators, especially children, near the
machine while working with it.
4
Do not use the RE-BAR tier near
lammable substances.
Never use the RE-BAR tier near any
lammable substances or fumes. The fu-
mes from these can be sucked into the
engine and cause an explosion.
Do not use the RE-BAR tier in wet
or damp environments.
If the RE-BAR tier is used in direct rain
or water, damp environments or similar,
the risk of getting an electrical chock is
increased. Do not leave the RE-BAR tier
where it can be exposed to this.
ENG