Silvercrest 77153 Instrucciones De Uso página 40

Steam ironing
• Programme the steam regulator 3 to the desired
steam setting.
• The temperature regulator 7 must be turned into
at least the adjustment range
cannot produce any steam.
Ironing with steam blast
The steam blast is especially suitable for smoothing
difficult to reach parts of a garment.
• Slightly raise the steam iron.
• For a steam blast, press the steam blast button
5.
Temporarily setting the steam
iron aside
Risk of fire!
NEVER leave the hot, mains-connected or switched-
on steam iron unattended.
• Place the temperature regulator 7 into the
position "MIN".
• Place the steam iron only on the cable base 8
or insert it onto the station q.
Taking the steam iron out of
service
• Remove the plug from the wall power socket.
• Empty the water tank and clean the ironing sole
. Otherwise it
• Place the cooled down steam iron on the station
• The power cable 9 can be wrapped and stored
Drip-Stop Function
With conventional steam irons it can happen that
water drips from the ironing sole e at low tempera-
tures. This iron however possesses a new equipment
characteristic, the DRIP-STOP function. At low tem-
peratures the iron automatically switches off the
steam-blast function. When this happens, a "CLICK"
is to be heard. You must then re-set a suitable tem-
perature with the temperature controller 7. As soon
as this is reached, steam production is continued.
- 38 -
e.
q and secure it, in that you slide the unlocking
switch 0 into the position
around the cable retainer w on the underside of
the station q:
.