Descargar Imprimir esta página

Ryobi RY40800 Manual Del Operador página 212

Equipo quitanieve de 40 v

Publicidad

Idiomas disponibles

Idiomas disponibles

PRODUCT SPECIFICATIONS
ENGINE
Engine Type ...................................................... 420cc OHV
Spark Plug .......................................LG F7TC or equivalent
Lubricant Fill Volume ........................ approximately 32 oz.
Fuel Volume ................................................................ 6 gal.
*Rated output determined by PGMA Standard G300
KNOW YOUR GENERATOR
See Figure 2.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AC CIRCUIT BREAKERS
The circuit breakers are provided to protect the generator
against electrical overload. The circuit breaker may be reset
by pressing the circuit breaker reset button.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
DIGITAL DISPLAY
The digital display shows AC voltage output, frequency, how
long the engine has been running during the current usage
period, and the total number of hours the unit has been used.
ENGINE SWITCH/FUEL VALVE/
CHOKE LEVER
The engine switch/fuel valve/choke lever is used when start-
ing, stopping, and running the engine.
FUEL TANK
The fuel tank has a capacity of 6 gallons.
FEATURES
GENERATOR
Rated Voltage ................................................ 120 V / 240 V
Rated Amps .................................................54.2 A / 27.1 A
Rated Output*........................................................ 6,500 W
Starting Watts ........................................................ 8,125 W
Rated Frequency ....................................................... 60 Hz
GROUND TERMINAL
The ground terminal is used to assist in properly grounding
the generator to help protect against electrical shock. Consult
with a qualified local electrician for grounding requirements
in your area.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of
lubricant in the crankcase is insufficient.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAIN PLUG
When changing the engine lubricant, unscrew and remove
the oil drain plug to allow old engine lubricant to be drained.
RECEPTACLES
Your generator has the following single phase, 60 Hz outlets:
two 120 Volt AC, 20 Amp duplex GFCI receptacles and one
240 Volt AC 30 Amp receptacle. These can be used for
operating appropriate appliances, electrical lighting, tools,
and motor loads.
RECOIL STARTER GRIP
The recoil starter grip is used to start the generator's engine.
Page 10 — English

Publicidad

loading