Tool it PBT 812 Manual De Uso página 15

Operating manual
PAPER REPLACEMENT
1. Open the paper roll cover.
2. Place a new paper roll in the compartment. Make sure the thermal side is upside placed as below.
3. Pull a short length of paper from the compartment and press down the cover to close.
PRECAUTIONS FOR USING THE INTEGRATED PRINTER
To prevent overheating the integrated printer, it is not recommended to operate the printer continuously without short
breaks. The printer should be rested for at least 1 minute for every 2 minutes of continuous use.
There is no need to be worried under normal operation, where one test only requires one printout and continuous prin-
ting is highly unlikely. However, if the integrated printer does start to get warm, please allow it to cool down by tempo-
rarily halting any printing actions.
HOW TO REPLACE CLAMP SET
1. Detach the clamp set when in need of replacement.
2. Make sure the new clamp set is properly connected.
* Do not detach the cables unless necessary to ensure the pins are not exposed to the moisture and acidic liquids
which could cause rusting and corrosion.
INSTALL / REPLACE THE INTERNAL BATTERIES
The tester offers two different options for its internal batteries.
A. 6pcs AA batteries.
B. 2pcs 18650 rechargeable lithium batteries.
IMPORTANT
It is recommended that the user to apply protected type 18650 lithium batteries instead of unprotected type
18650 batteries.
Because the circuit of the protected type 18650 battery is embedded in the cell packaging (battery casing)
which protects the cell from "over charge", heat or
"over discharge", over current and short circuit and less likely to overheat, burst or start on fire.
Translation of the original
instructions
PBT 812
15