Tool it PBT 812 Manual De Uso página 18

Operating manual
SURFACE CHARGE
If the tester detects a surface charge, a pop-up notification will ask the user to turn on loads/headlights for 15 seconds
to eliminate the surface charge.
Please note that vehicles with LED headlights and modern vehicle control modules might not be able to eliminate
surface charge within 15 seconds and the pop-up may continue. Turn on more loads and repeat the process if this
problem persists.
BATTERY TEST RESULTS
1. GOOD & PASS
The battery is good and capable of holding a charge.
2. GOOD & RECHARGE
The battery is good but needs to be recharged.
3. CAUTION
The battery may be serviced but performance will decline gradually. The battery may fail under extreme weather
conditions and should be closely monitored, replacement might be necessary. Check battery connection and charging
system to ensure the battery is properly charged.
4. RECHARGE & RETEST
Battery is discharged, the battery condition cannot be determined until it is fully charged. Recharge and retest the
battery.
5. BAD & REPLACE
The battery will not hold a charge. It should be replaced immediately.
6. BAD CELL & REPLACE
The battery has at least one cell short circuit. It should be replaced immediately
7. LOAD ERROR
Failed to measure battery condition, please make sure the battery is not over 3000CCA/SAE, clamps are properly
connected to the battery, and clamps/cables are in a good state. Clamp/cable condition can be determined with the
"Cable Diagnosis" tool. If the problem persists or clamp/cable need replacing, ask your dealer for replacement parts
or further diagnostics.
18
Translation of the original
instructions
PBT 812