Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
•
The cooktop must be set into a
worktop between 20 mm and
50 mm deep.
•
Install a separator panel under
the hob.
•
The lower part of the product
must not be accesible after
installation.
•
Do not fit the separator panel if an undertop oven is installed.
•
There must be nothing between the cooktop and the oven (cross rails,
brackets, etc.).
•
The distance between the lower face of the glass ceramic hob and the
cupboard or separating panel must be at least 20 mm.
•
If the cooktop is to be installed next to a column unit, leave a distance of at
least 100 mm from the edge of the cooktop to the side of the column unit.
•
For built-in dimensions and installation see the picture in this paragraph.
•
A minimum distance must be maintained between the hob and the hood
above it. Please refer to the user manual of the hood for more informations.
•
Apply the supplied gasket to the cooktop (unless it has already been fitted),
after having cleaned its surface.
•
Do not install the cooktop near a dishwasher or washing machine, so that
the electronic circuits do not come into contact with steam or moisture,
which could damage them.
•
If an oven is installed beneath the cooktop, make sure that it is equipped
with a cooling system. If the temperature of the electronic circuits
exceeds the maximum permitted temperature, the cooktop will switch
o automatically; in this case, wait for a few minutes until the internal
temperature of the electronic circuits reaches a tolerable level, at which
point it will be possible to switch the hob on again.
Placing the hob
1. Turn the cooktop down and place on smooth ground.
9
min. 20 mm
min. 20 mm
Publicidad
