7.2 Special instructions for facial treatments
WARNING
• If the distance to the eye is less than 20cm, we recommend using safety glasses.
We recommend using safety glasses approved in accordance with Regulation
(EU) 2016/425 and tested in accordance with EN 166:2001 and ISO:12609–1:2021
standards.
• Men must not use this device on the face.
• Do not use the device on the face at an intensity level higher than 2.
• Do not use the device on the face above the cheek line or on the eyes, eyebrows or
eyelashes, as this could result in severe damage to the eyes. Do not use the device on
mucous membranes in the ear or nose area.
• The skin on your face is very sensitive and requires special care. It is essential to
observe all warnings and safety notes in these instructions for use to prevent adverse
consequences. We recommend that you first perform a treatment on your body and
get to know the device before performing facial treatment. The device can be used
to treat all areas of the face below the cheek line, such as the upper lip, cheeks, jaw,
chin and neck.
1. It is essential to carry out a selective skin sensitivity test 48 hours before treatment (see
chapter "6.2 Skin sensitivity test"). The skin sensitivity test should be performed on an
area without hair, such as below the ear or on the side of the neck, to determine the
suitable intensity level.
WARNING
Do not treat the tested area until at least 1 week after performing the skin sensitivity
test.
2. Mark the treated area with a white eyeliner pencil. Use the marking as a reference line
for issuing the pulses. This way you can prevent overlapping the treatment areas or
treating other areas of the face by mistake.
3. Use a mirror to position the device correctly on the treatment area.
4. Follow the instructions for use and observe the following specific instructions in particular.
Treating the upper lip
Position the light area
in every marked zone.
Avoid applying the treatment to the nostrils and lips, as these areas are more
sensitive.
You can "fold in" your lips or press them together to make the treatment area
more taut, or apply a thick layer of white eyeliner to the lips and around the
edge of the lips. The white line ensures that the energy of the flash is reflected
and does not reach your lips, should you accidentally apply a pulse to your lip.
of the device as shown in the figure. Trigger a pulse
1
38