Beurer IPL 7800 Cool Pro Manual De Instrucciones página 40

7.4 After treatment
1. When you have completed the hair removal session, press and hold the ON/OFF/
intensity button
is indicated by the ON/OFF/intensity button
2. In standby mode, the fan will continue to run for a few seconds until the device has
cooled down.
3. Once the fan has switched off, remove the mains adapter from the mains socket.
 CAUTION
After treatments, do not use any antiperspirants/deodorants as these may cause skin
irritation.
8. CLEANING AND MAINTENANCE
We recommend cleaning your device and especially the light area
removal session.
When cleaning, do not use any solvents or other aggressive or abrasive cleaning
agents, as the surface may become damaged.
Never immerse the device or parts of the device in water!
1. Before cleaning, remove the mains adapter of the device from the socket.
2. Clean the housing of the device with a dry, clean cloth.
3. Gently clean the light area
a slightly damp lint-free cloth.
9. WHAT IF THERE ARE PROBLEMS?
"The device will not switch on"
• Ensure that the mains cable is correctly connected to the device.
• Ensure that the mains adapter is inserted into a wall socket.
"No light pulse is emitted when I press the trigger button
• Ensure that the device is in full contact with the skin and that the light area
skin contact sensor
the trigger button only activates a pulse if the skin contact sensor
contact with the skin.
• If the skin contact indicator lamp
the contact with the skin, as measured by the skin contact sensor
Increase the level of contact with the skin or contact Customer Services.
for 2 seconds. The device switches to standby mode. Standby mode
8
and skin contact sensor
1
are pressed onto the skin evenly and firmly. For your safety,
2
5
permanently lighting up.
8
on the device is not illuminated, this indicates that
40
after each hair
1
using
2
"
6
has sufficient
2
, is insufficient.
2
and
1