Publicidad
Step 10
Lay the UPPER BACK (H2) over your unit.
å
Push the SAFETY STRAP through the large hole in the
å
UPPER BACK (H2).
Fasten the UPPER BACK (H2) to the BACK (K). Use fi ve
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
Check to be sure you have equal margins on the side and
å
top edges of the UPPER BACK (H2). Finish fastening the
UPPER BACK (H2) to your unit using the NAILS (1N).
Peel a FELT DISC from the FELT DISC CARD (1M) and stick
å
them on the ENDS (A2 and B2) and BASE (E2) as shown.
Push the
SAFETY STRAP
through the hole.
NAIL
(17 used for the BACK)
Page 14
H2
A2
1N
Caution
Do not stand the unit upright without the
BACK (H2) fastened. The unit may collapse.
BLACK 9/16" LARGE HEAD SCREW
K
419152
1S
(5 used in this step)
B2
E2
1M
www.sauder.com/service
Publicidad
