DeWalt D25501 Manual De Instrucciones página 35

3. If the chisel groove is not aligned with the symbol, or is not
inserted to the complete depth the lock symbol remains open.
To remove the bit, pull back the locking sleeve and pull the bit out.
FIG. 4
M
P
Inserting and Removing SDS Max
Accessories (Fig. 4)
D25501, D25602, D25820, D25831
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
1. Pull back the locking sleeve (P) and insert the bit shank. The bit
shank must be clean.
2. Turn the bit slightly until the sleeve snaps back into position.
3. Ensure the bit is properly engaged.
NOTE: The bit needs to move several centimeters in and out of
the tool holder (M) when properly engaged.
4. To remove the bit, pull back the locking sleeve and pull the bit out.
Complete Torque Control (Fig. 5)
D25602
R
NOTICE: Always turn the tool off before changing torque control
settings or damage to tool may result.
Q
The Complete Torque Control (CTC) feature of this tool is designed to
provide additional control with a two-stage clutch mechanism.
Clutch Setting 1 (S) is designed for most hammerdrilling applications
and is designed to easily clutch out when the drill bit encounters
re-bar or other foreign substances.
Clutch Setting 2 (T) is
designed for higher torque
applications such as core-
bits
hammerdrilling
designed to clutch out at a
higher torque threshold.
Move the torque control
®
lever (U) to setting 1 or 2 as
needed for application.
NOTE: Allow the motor
housing to rotate a little
while changing torque.
Each
is
automatically default to
clutch setting 1, the most
sensitive setting.
33
FIG. 5
and deep hole
and is
S
T
U
G
V
W
time the tool
plugged in, it will