Triton TMNRTR Instrucciones De Uso página 22

Troubleshooting
Problem
Inaccurate cutting profile
Router (1) will not operate
Router runs or cuts slowly
Excessive vibration
Heavy sparking occurs inside motor
housing
Micro Winder (20) "clicks" or not adjusting
on Plunge Base (9)
Makes an unusual sound
EN
22
817698_OwnerManual.indd 22 817698_OwnerManual.indd 22
Possible cause
Depth Stop (30) / depth (Trimmer Base) not
correctly adjusted
Incorrectly fitted or loose Router Bit/Collet/
Collet Nut (48, 3 or 17)
No supply of power
Brushes worn or sticking
ON/OFF Switch (10) is faulty
Motor components faulty or short circuited
Blunt or damaged cutter/Router Bit
Speed Dial (11) set low
Motor is overloaded
Incorrectly fitted or loose Router Bit
Bent or damaged Router Bit
Brushes not moving freely
Damaged or worn motor
Plunge Lock Lever (24) engaged
Reached end of adjustment range
Mechanical obstruction
Damage to internal windings
Solution
Ensure the Depth Stop/trimmer height
corresponds to the maximum amount of
cut permitted by the Depth Turret (31) /
Trimmer Depth Micro Adjustment Dial (46)
Tighten Router Bit/Collet/Collet Nut and
cutter assembly
Check that power is available at source
Disconnect power, open Brush Access
Covers (12) and ensure brushes are not
damaged or heavily worn. If worn, replace
brushes (see 'Brushes' or have the tool
serviced by an authorised Triton service
centre)
Have the tool serviced by an authorised
Triton service centre
Have the tool serviced by an authorised
Triton service centre
Re-sharpen or replace cutter/Router Bit
Increase variable speed setting
Reduce pushing force on Router
Re-fit or tighten Router Bit and Collet
Nut (17)
Replace Router Bit
Disconnect power, remove brushes, clean
or replace (see 'Brushes')
Have the tool serviced by an authorised
Triton service centre
Release Plunge Lock Lever
Reset Micro Winder and set depth with the
Depth Stop
Have the tool serviced by an authorised
Triton service centre
Have the tool serviced by an authorised
Triton service centre
11/11/2022 10:25 11/11/2022 10:25