ALPA Exacto BA070 Manual De Instrucciones página 6

ALPA_MICROMETER_EXACTO_IP65
FAILURE
Display "E 1"
Display "E 2"
Display "E 3"
Measuring value is not correct
Display is confusing or dead
No display
Display is blurring
Appears
CAUSES
Measuring value over display range
The origin is too great
1. The micrometer is disturbed
2. Something wrong with sensor
1. Measuring surface are dirty
2. The origin isn't correct
Suffer to strong disturb
Battery voltage < 1.45V
REPAIRING
Reset the origin or convert to relative
measuring mode
Reset the origin
1. Replace the battery
2. Return the micrometer for repair
1. Clean measuring surfaces
2. Reset the origin
Reset battery
Replace battery