Align The Blade To The Table - Delta ShopMaster S26-262L Manual De Instrucciones

ALIGN THE BLADE TO THE
TABLE
Refer to Figure 12.
1. Unplug the saw.
2. Lower the saw arm all the way down to the transport
position and engage the lock pin to hold it in place.
3. Loosen the mitre lock handle (A), and position the
table so that the mitre scale indicator (B) reads 0°.
4. Tighten the mitre lock handle so that the table will not
move.
5. Loosen bevel lock knob (C) and adjust the angle
of the saw arm so that the bevel scale indicator (D)
reads 0°. This positions the blade at 90° to table.
6. Securely tighten bevel lock knob.
Refer to Figure 13.
7. Place a combination square (E) against the table and
the face of the saw blade (F) square contacts the flat
part of the saw blade, not the blade teeth.
8. Rotate the blade by hand and check the blade-to-
table alignment at several points.
9. The edge of the square and the saw blade should be
parallel as shown in Figure 13.
10. If the top or bottom of the blade face is not flush with
the square, refer to Figure 14 below and perform the
following steps.
11. Loosen bevel lock knob (G).
12. Adjust positive stop adjustment screw (H) to bring
saw blade into alignment with the square. See
"Positive Stop Screw" in the Adjustment section.
13. Retighten bevel lock knob. Recheck blade-to-table
alignment.
NOTE: The above procedure can be used to check
alignment of the blade to the mitre table at both 0° and
45° angles.
NOTE: The saw has two scale indicators, one on the
bevel scale and one on the mitre scale. After squaring
adjustments have been made, it may be necessary to
loosen the indicator screws and reset them to zero.
PREPARING YOUR SAW FOR USE
C
D
G
H
13
B
FIGURE 12
E F
FIGURE 13
FIGURE 14
A