Total Open/Close Programming - Erreka AM600S Manual Del Instalador

3

TOTAL OPEN/CLOSE PROGRAMMING


The programming of the gate open/close is done
using the transmitter, the ST1 mini-pushbutton or
the total key command (A.T.).
Start programming mode
Programme the slowdown start points
Finish the programming mode

The total opening and closing of the gate will be
memorised.

The positions in which the gate begins to slow
down, both on opening and in closing, will also
be memorised.
PROGRAMMING AND STARTUP

Before making the programming, ensure there
is no person, animal or object in the radius of
action of the gate and the mechanism.
1 Close the gate by pressing PUL1.
2 Ensure that DIP7 is "OFF" if the operator does not
have an encoder, or "ON" if an encoder is fitted.

If the encoder is not enabled (DIP7=OFF),
operation times will be memorised.
3 Place DIP8 in "ON" (slowdown).
4 Place DIP1 and DIP2 in "ON"; DIP3, DIP4, DIP5 and
DIP6 in "OFF".

DL3 lights up,
programming mode.
1 Start to open the gate: press ST1; the gate begins
to open.
2 Start slowdown in opening: press ST1 (or A.T. or
the transmitter) when the opening limit switch
magnet is approximately 50 cm from the end of the
run, in order to start slowdown (DA1).
3 Wait for the gate to come to a halt due to the
action of the opening limit switch.
4 Start closing the gate: press ST1; the gate begins
to close.
5 Start slowdown in closing: press ST1 (or A.T. or
the transmitter) when the closing limit switch
magnet is approximately 50 cm from the end of the
run, in order to start slowdown (DC1).
6 Wait for the gate to come to a halt due to the
action of the closing limit switch.
1 Place DIP1 and DIP2 in "OFF".

DL3 will remain off.
indicating that it is
Control board AM600S-AM606S
in
27