Milwaukee M18 FUEL 2736-20 Manual Del Operador página 8

Selecting, Installing, and Changing Blades
Do not use blades rated less than
WARNING
the speed of this tool. Failure to
heed this warning could result in personal injury.
Use the appropriate saw blade for
WARNING
the riving knife. Match kerf width
of blade (>1.8 mm) and blade body thickness
(<1.55 mm) with the marking on the riving knife
to reduce the risk of kickback. Failure to heed
this warning could result in personal injury.
Blades are sharp. Wear work gloves
WARNING
when handling blades.
To work properly, the saw blade teeth
NOTICE
must point down toward the front of
the saw. Failure to heed this warning could cause
damage to the saw blade, the saw, or the work-
piece.
Always use clean, sharp blades. Dull blades tend to
overload the tool, bind, and cause pinching. Use only
8-1/4" table saw blades rated at least 6300 RPM.
The blade provided with the saw is a high-quality
combination blade suitable for ripping and cross cut
operations.
Blade kerf width and blade body thickness must be
within the limits stamped on the riving knife. Do not
use metal-cutting blades. Do not cut plastics.
The blade wrench should be stored on the table
saw frame (see "Functional Description" for storage
location).
NOTE: To replace the blade with an accessory blade,
follow the instructions provided with the accessory.
To change the saw blade:
1. Remove the battery pack.
2. Set the blade angle (bevel) to 0° and lock it in
place.
3. Raise the blade by turning the height adjusting
wheel clockwise.
4. Remove the riving knife.
5. Remove the throat plate.
6. Press in the spindle lock and rotate the spindle/
blade until the lock engages.
7. Use the blade wrench to loosen the blade bolt
counterclockwise. Carefully remove the blade
bolt and blade flange by hand. Remove the blade.
Wipe the blade bolt, flanges and spindle to remove
dust and debris. Inspect the parts for damage.
Replace if needed.
8. Match the arrow direction on the replacement saw
blade with the arrow direction on the riving knife.
The teeth should point toward the front of the table
saw. Slide the blade onto the spindle.
9. Install the outer blade flange. The flat side of the
flange must rest against the blade.
Spindle lock
10. Hand-thread the blade bolt. Once the spindle
starts to spin, press in the spindle lock and rotate
the blade until the lock engages. Securely tighten
clockwise with the blade wrench.
11. Reinstall the appropriate throat plate, riving knife,
and anti-kickback pawls for the application.
12. Check blade guard and anti-kickback pawls move
freely before starting the saw. Ensure the blade
teeth match the direction of rotation indicated on
the riving knife.
Changing the Throat Plate
Always use the appropriate throat
WARNING
plate for the operation. Different
blades may require different throat plates. Never
operate the saw without a throat plate in place.
1. Remove the battery pack.
2. Lower the blade by turning the height adjusting
wheel counterclockwise.
3. To remove a throat plate, turn the throat plate
latch to unlocked.
Throat plate
4. Use the hole to lift the throat plate out.
5. To install a throat plate, slide the back end into the
slot and drop the front into place. Turn the throat
plate latch to locked. The throat plate must be
flush with the saw table.
8
Throat plate latch
Lift hole