Cutting equipment
Select correct cutting equipment and do maintenance on
the cutting equipment to:
•
Get maximum cutting performance.
•
Increase lifetime of the cutting equipment.
WARNING:
attachments with the guards we
recommend! See
Refer to the instructions for the cutting
attachment to find the correct way to load
the trimmer line and the correct trimmer line
diameter.
WARNING:
attachment may increase the risk of
accidents.
WARNING:
before you do the work on the cutting
attachment. This continues to rotate after
you release the throttle. Make sure that the
cutting attachment has stopped fully and
disconnect the spark plug cap before you
start the work on it.
Trimmer head
WARNING:
trimmer line is wound tightly and evenly
around the drum to prevent harmful
vibration.
•
Only use recommended trimmer heads and trimmer
lines.
•
Only use recommended cutting attachments.
•
Smaller machines requires small trimmer heads and
vice versa.
WARNING:
before you do any work on the cutting
attachment. The cutting attachment
continues to rotate even after the throttle
has been released. Ensure that the cutting
10
Only use cutting
Accessories on page 21 .
A defective cutting
Always stop the engine
Always make sure the
Safety instructions for maintenance
Always stop the engine
•
The length of the trimmer line is important. A longer
trimmer line requires greater engine power than a
shorter trimmer line of the same diameter.
•
Make sure that the cutter on the trimmer guard is
intact. This cuts the trimmer line to the correct
length.
•
Soak the trimmer line in water for a couple of days
before use to increase the life length.
Fuel Safety
WARNING:
instructions that follow before you use the
product.
•
Never start the product if you spill fuel on it. Wipe the
spillage of and allow remaining fuel to evaporate.
•
Never start the product if you spill fuel on yourself or
your clothes. Change your clothes and wash any
part of your body that has come in contact with fuel.
Use soap and water.
•
Never start the product if the product is leaking fuel.
Check regularly for leaks from the fuel cap and fuel
lines.
•
Always put the product on a flat surface and make
sure the cutting attachment cannot come in contact
with any object while you add fuel.
•
Take care when handling fuel. Bear in mind the risk
off fire, explosion and inhaling fumes.
•
Observe caution when handling fuel and make sure
there is adequate ventilation. Fuel and fuel fumes
are highly inflammable and can cause serious injury
when inhaled or allowed to come in contact with the
skin.
•
Mix and pour fuel outdoors, where there are no
sparks or flames.
•
Do not smoke or place hot objects near fuel.
•
Always stop the engine and let it cool off for a few
minutes before you refuel.
•
Open the fuel cap slowly so that any excess
pressure is released gently when you refuel.
•
Tighten the fuel cap carefully after you refueled.
•
Clean the area around the fuel cap. Contamination in
the tank can cause operating problems.
•
Always move the product 3m (10ft) or further from
the refuelling area and source before starting.
attachment has stopped completely and
disconnect the spark plug before you start to
work on it.
Read the warning
1309 - 004 - 23.03.2021