Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO REPLACE THE MAIN BURNER
1. Open the grill hood and remove the warming rack (A), cooking
grates (B) and flame tamers (C).
2. Remove the cotter pin from the main burner. (Fig. 1)
3. Remove the two screws that attach the main burner electrode and
wire to the main burner.
4. Remove and discard the old main burner. Replace with new one.
Note: When reinstalling the main burner make sure the main valve
stem is inserted into main burner tube opening.
5. Reinstall the cotter pin and the two screws that attach the main
burner electrode and wire.
6. Replace the flame tamers, cooking grates and warming rack.
HOW TO REPLACE THE ELECTRONIC IGNITION AND MAIN
BURNER ELECTRODE WIRE
1. Open the grill hood and remove the warming rack (A), cooking
grates (B) and flame tamers (C).
2. Remove the two screws that attach the main burner electrode and
wire to the main burner. (Fig. 1)
3. From underneath the grill just above the left side cart door,
remove the two screws holding the ignition heat shield in place.
Remove the heat shield through the opening just above the door.
(Fig. 2)
4. Unscrew the push button igniter button and lock nut, then remove
the push button igniter through the same opening. Unplug the
main burner electrode wire that you are replacing from the back
of the push button igniter, then remove the electrode and wire
from the grill. (Fig. 2)
5. Feed the new main burner electrode wire through the hole on the
inside of the grill, then reinstall the main burner electrode with
the two screws previously removed. (Fig. 3)
6. Plug the wire into the back of the push button igniter where the
previous wire was removed. (Fig. 4)
7. Reinstall the push button, then reinstall the ignition heat shield
with the two screws previously removed.
8. Replace the flame tamers, cooking grates and warming rack.
REPLACING THE MAIN BURNER
FIG. 1
FIG. 2
Fixed Screws
Ignition heat shield
FIG. 3
Push button igniter
lock nut and push
button
FIG. 4
igniter
EN-27
"Cotter" Pin
Fixed Screws
Ignition heat shield
Ignition wire
Publicidad
