Publicidad
Idiomas disponibles
Idiomas disponibles
n)
Do not process two workpieces at the same time.
o)
The product is not a toy. Cleaning and maintenance must not be performed by children without adult
supervision.
p)
Do not tamper with the device to alter its performance or design.
q)
Keep the unit away from sources of fire and heat.
r)
Do not block the ventilation openings of the unit!
s)
It is forbidden to insert fingers/hands into the openings of the cable/wire feeder during the operation
of the device.
t)
After each use, make sure that the device is free from excessive dust, dirt, grease, etc.
CAUTION! Although the product has been designed to be safe and have adequate safeguards, and
despite the additional safety features for the user, there is still a slight risk of accident or injury when
handling the unit. Caution and common sense are advised when using the product.
3. Instructions for use
The machine is designed for cutting insulation from copper and aluminum wires and cables of various
diameters.
The user is responsible for any damage resulting from misuse.
3.1.
Product overview
3.2.
Preparation for operation
POSITIONING OF THE UNIT
The ambient temperature must not exceed 40°C and ambient humidity should not exceed 85%. Place the unit
in a way that ensures good air circulation. Maintain a minimum clearance of 10 cm from any wall of the unit.
Keep the unit away from any hot surfaces. Always operate the unit on a level, stable, clean, fireproof, and dry
surface and out of the reach of children and persons with impaired mental, sensory, and intellectual
functions. Place the unit in such a way that the main plug can be reached at any time. Ensure that the power
supply to the unit corresponds to that specified on the identification plate!
1 - pressure adjustment knob
2 - blade retaining screw
3 - lock nut
4 - board with holes for cables
5 - mounting plate
6 - ON / OFF switch buttons
7 - blade speed adjustment buttons
8 - mounting holes for fixing the machine
to the ground
Publicidad
