RCA RCR311S Manual Del Usuario página 10

RCR311S_NA_IB_REVB_K4.qxd 7/27/04 11:41 AM Page 10
Programming Methods (continued)
ON•OFF
•
VCR DVD
(BLINK)
•
VCR DVD
•
VCR DVD ON•OFF
(BLINK)
4. Press and hold the component key
•
VCR DVD
•
TV SAT CBL
ON•OFF
5. While holding the component key
(BLINK)
6. After holding down both keys for
•
ON OFF
7. Release both keys. The illuminated
!
TIP:
of each key, be sure to keep the remote
pointed at the IR sensor of the
component you are currently
programming the remote to control.
8. Press and release the PLAY key,
PLAY
ON•OFF
(BLINK)
9. When your component turns off,
REVERSE ON•OFF
(BLINK)
10
a. Press and hold the VCR•DVD
key. The illuminated ON•OFF
key turns on.
b. While holding down the
VCR•DVD key, press and
release the number 2 key on
the keypad to control a VCR or
the number 3 key to control a
DVD. The illuminated
ON•OFF key turns off.
c. Release the VCR•DVD key.
The illuminated ON•OFF key
blinks four times and then
turns off. Your remote is now
either in VCR or DVD
Programming Mode,
depending on which you
chose. Proceed to step 4.
(TV, VCR•DVD, SAT•CBL) you
wish to program. The illuminated
ON•OFF key turns on and
remains on.
down, press and hold the ON•OFF
key. The illuminated ON•OFF key
turns off.
three seconds, the illuminated
ON•OFF key turns back on.
ON•OFF key remains on.
Throughout the programming
then wait five seconds to see if
your component turns off. If your
component does not respond,
continue to press the PLAY key
every five seconds until your
component turns off. Each time
you press the PLAY key, the
illuminated ON•OFF key blinks
and a block of 10 codes are sent to
your component. This process
continues until all of the codes in
the Code Lists have been searched.
(If your component has not turned
off after all codes have been
searched, the illuminated ON•OFF
key blinks four times and turns
off. The Auto Code Search Entry
method is exited.)
you know the correct code is in
the last block of 10 codes sent.
Press and release the REVERSE
key. Wait two seconds to see if
your component turns on again. If
your component does not respond,
continue to press the REVERSE
key every two seconds until your
component turns on again. This
will isolate the correct code in the
last block of codes sent. Each time