RCA RCR311S Manual Del Usuario página 7

RCR311S_NA_IB_REVB_K4.qxd
!
TIP:
of each key, be sure to keep the remote
pointed at the IR sensor of the
component you are currently
programming the remote to control.
6. To confirm that the component key
7. Remember to enter the code for
Manual Code Search and Entry
If your component's brand isn't listed in the Code Lists, or if
you have tried all of the codes for your brand and the remote
does not operate your component, try one of the Code Search
methods below—Manual Code Search or Auto Code Search.
Both Code Search methods cycle through all of the codes in the
Code Lists in the event that your component's code is listed
under another brand.
The Manual and Auto Code Search methods may take a long
time because the remote searches through all of the codes in its
memory for the code that operates your component. Therefore,
if your brand is listed in the Brand Codes or the Code Lists,
first try the Brand Code Search or the Direct Code Entry
methods described on pages 4 and 6.
! TIP:
GO BACK
point in the Manual Code Search, press
and release the GO BACK key.
1. Manually turn on the component
2. If you are programming the remote
3. To program the remote to control
ON•OFF
•
VCR DVD
(BLINK)
7/27/04 11:41 AM Page 7
Throughout the programming
is programmed with the correct
code for maximum functionality,
test the component. Attempt to
control a variety of the
component's functions with the
remote. If some of the features of
your components do not work, try
programming the remote with a
different code in the list until you
find the code that allows the
remote to control the majority of
your component's functions.
Different codes can provide
different levels of functionality.
future reference in the box provided
in the Code Retrieval section of this
manual (See page 12).
To exit without saving at any
you want the remote to control.
Note: If you press an invalid key
during the Manual Code Search,
the remote does not respond and
the search times out after two
minutes. When the search times
out, the illuminated ON•OFF key
blinks four times and turns off. The
last programmed code under
that component key is retained.
to control your TV, satellite receiver
or cable box, go directly to step 4.
a VCR or DVD. The VCR•DVD
key can control only one
component, either your VCR or
your DVD. To program your
remote to control either your DVD
or your VCR, you must first put the
remote in the proper programming
mode. Follow these directions
before proceeding to step 4.
a. Press and hold the VCR•DVD
key. The illuminated ON•OFF
key turns on.
7