Publicidad
Idiomas disponibles
Idiomas disponibles
RCR311S_NA_IB_REVB_K4.qxd 7/27/04 11:41 AM Page 12
Code Retrieval (continued)
5. Starting with the number 1 key,
ON•OFF
6. Repeat step 5 until you have
ON•OFF
7. After the fourth number is
(BLINK)
8. To exit the Code Retrieval Mode,
GO BACK
9. If you press an invalid key during
TV CODE
1
VCR
SAT
5
Using the Remote to
Control Your Components
Because this remote controls more than one component, you
must first "tell" the remote which component you wish to
operate. That means, if you wish to operate your TV, you
must first press the TV key to put the remote in the TV Mode.
The remote stays in the chosen component mode (such as TV
Mode) until you change it. If your remote is in TV Mode, you
must change the mode in order to operate your DVD or VCR,
satellite receiver or cable box. For example, if you are in VCR
Mode, and you wish to turn off your TV, you must press the
TV key first before pressing the ON•OFF key.
12
press and release each number key
on the keypad in the following
order (1-9, then 0). The number
that causes the illuminated
ON•OFF key to blink is the first
number of the code. As you find
each number of the code, refer to
the code boxes below and write
them down for future reference.
All TV codes begin with the
Note:
number 1; all VCR codes begin
with the number 2; all DVDs, the
number 3; and all satellite
receivers and cable boxes, the
number 5.
retrieved all four numbers in
the code.
retrieved, the illuminated ON•OFF
key blinks briefly, then turns off.
press and release the GO BACK
key at any time.
the Code Retrieval process, the
remote will not respond. If you do
not press a valid Code Retrieval
key (TV, VCR•DVD, SAT•CBL,
INFO, GO BACK), Code Retrieval
times out after 15 seconds. The
illuminated ON•OFF key blinks
four times, and then turns off.
·
DVD CODE
·
CBL CODE
Publicidad
