RCA RCR311S Manual Del Usuario página 8

RCR311S_NA_IB_REVB_K4.qxd
Programming Methods (continued)
•
VCR DVD
•
VCR DVD ON•OFF
(BLINK)
4. Press and hold the component key
•
VCR DVD
•
TV
SAT CBL
•
5. While holding the component key
ON OFF
ON•OFF
6. After holding down both keys for
7. Release both keys. The illuminated
(BLINK)
ON•OFF
!
TIP:
of each key, be sure to keep the remote
pointed at the IR sensor of the
component you are currently
programming the remote to control.
8. Press and release the ON•OFF key
•
ON OFF
ON•OFF
(BLINK)
9. Once your component turns off,
STOP
•
ON OFF
Testing the Code for
Maximum Functionality
To confirm that the component key is programmed with the
correct code for maximum functionality, it is necessary to test
the component. If some of the features of your component do
not work, different codes in the list can be tried until you find the
code that allows the remote to control the majority of your
component's functions. Different codes can provide different
levels of functionality. Follow these steps to test for maximum
functionality.
8
7/27/04 11:41 AM Page 8
b. While holding down the
VCR•DVD key, press and
release the number 2 key on the
keypad to control a VCR or the
number 3 key to control a DVD.
The illuminated ON•OFF key
turns off.
c. Release the VCR•DVD key. The
illuminated ON•OFF key blinks
four times and then turns off.
Your remote is now either in
VCR or DVD Programming
Mode, depending on which you
chose. Proceed to step 4.
(TV, VCR•DVD, SAT•CBL) you
wish to program. The illuminated
ON•OFF key turns on and
remains on.
down, press and hold the ON•OFF
key. The illuminated ON•OFF key
turns off.
three seconds, the illuminated
ON•OFF key turns back on.
ON•OFF key remains on.
Throughout the programming
repeatedly, waiting 4 seconds
between each key press, until your
component turns off. Each time
you press the ON•OFF key, the
illuminated ON•OFF key blinks,
and the next code is sent. This
process continues until all of the
codes in the Code Lists have been
searched. If your component turns
off, you have found the correct
code. (If it cycles through and the
illuminated ON•OFF key blinks
four times and turns off, all codes
have been searched. The Manual
Code Search method is exited.)
you have found the correct code.
You must save the new code by
pressing and releasing the STOP
key. The illuminated ON•OFF key
turns off. You must press the
STOP key to save the code or the
correct code will not be stored!