BQS BT012 Manual De Uso página 12

11. Check that the buckle is properly fastened. It is important that in the
event of an emergency the child can be released quickly.
12. Make sure the seat does not become caught by the vehicle´s door or
reclining seat. Likewise, check that the seat is properly and sufficiently
fitted.
13.Never try to remove, change or add pieces to the seat or harness
since their basic and security functions may be seriously affected.
14. Always fasten this safety seat into the vehicle with the seat belt, even
when not in use. Never leave your child unattended when seated or
not.
15. Contact our Customer Service for any question about installing this
child safety seat: +34 943 833 013.
16. Please keep this safety seat away from corrosive products.
17.The manufacturer guarantees the quality of its products but not the
quality of second-hand products or those registered under other
trademarks.
18.The illustrations in this instructions booklet are for information
purposes only. The child restraint may have small differences from the
photographs or images in this instructions manual. These variations do
not affect its approval by ECE Regulation 44/04.
1. USE IN VEHICLES.
3-point lap and
diagonal seat belt
2-point lap seat belt
Only suitable for this
particular seat WHEN an
airbag is NOT active.
Only suitable for this
particular seat WHEN having
a lap and diagonal seat belt
(3 anchor points)
Child restraint system
22
Correct installation /
proper
Incorrect installation /
improper
Optional installation
Optional installation
BT012
2. SEAT PARTS AND FITTINGS.
A. Cover.
B. Group 1 and 2 vertical belt hook.
C. Harness pads.
D. Vertical belt hook.
E. Armrest.
F. Group 0+ diagonal belt hook.
G. Harness straps.
H. Locking buckle.
I. Buckle pad.
J. Ergo seat cushion for group 0+ & 1.
K. Base Cover.
L. Harness adjustment button.
M.Harness adjuster strap.
N. Child seat gradient adjuster.
O. Harness pad connector.
P. User manual´s poquet.
Q. Metal harness connector.
3. INSTALLING CHILD SEAT. GROUP 0+.
WARNING
Do not use the child seat on a passenger seat fitted with an active
airbag.
1. Recline the seat as much as possible using handle
in position 1 (3.1).
2. Open the harness system by pressing
seat buckle (3.2).
3. Remove the inner cushion but keep it handy to later put in place (3.3).
4. Place the child seat on the vehicle seat facing backwards (3.4).
5. Lift the rear of the base cover, and pass the waist seat belt beneath it
passing through F guides and buckling it to the vehicle anchor point
until you hear a "click" (3.5).
6. Pass the diagonal vehicle shoulder belt through guide
Group 0+/1/2
Only suitable for Group 0+, approx.
0 to 10 months (0-13 Kg.)
N placing the back
H the red button on the child
D (3.6 and 3.7).
www.babyqs.com
EN
23