Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning
Clean the clipper and the blade after each use.
1. Brush off any hairs from the
clipper and from around the
blade.
2. Brush off the hairs from the
blade edge.
3. Brush the hairs out from
between the stationary blade
and the moving blade while
pressing down on the cleaning
lever to raise the moving blade.
12
Lubrication
• Apply the oil to the clipper before and after each use.
Apply a drop of the oil to each
indicated point.
Failure to apply the oil may cause the
following problems due to rust, wear or
burn out.
- The clipper has become blunt.
- Shorter operating time.
- Louder sound.
► Replacement parts
Replacement part is available at your dealer or Service Center
Replacement parts for ER‑GP80
Cleaning the charging stand
Use the cleaning brush to clean hair trimmings and dust in the
charging plug or in the hole on the bottom surface.
Blade
WER9900
Publicidad
