Celexon Leinwand Motor Professional Plus Manual De Instrucciones página 17

MOUNTING ON THE WALL
Measure the distance between the
holes in the side caps (two per cap)
and transfer them to the wall.
Drill the holes at the markings with the
holes with the right diameter for the
mounting material and make sure that
the drill holes are absolutely level (Use
a spirit level!).
Use dowels and screws that are suitab-
le for your mounting surface. Screw the
two upper screws into the wall most
of the way and hang the screen from
both sides into the upper hole. Make
sure that the screen is installed straight
and level. Tighten the screws and then
tighten the lower screws on both sides
of the screen.
Caution Do not overtighten the screws!
If you notice cracks in the caps they
must be replaced! The screen must not
be used with cracked caps. Please en-
sure that the metal shims are also used
for wall and ceiling mounting, other-
wise a safe installation cannot be gu-
aranteed).
6