Hilti GX 2 Manual De Instrucciones Original página 25

Status
All four LEDs light green.
Three LEDs light green.
Two LEDs light green.
One LED lights green.
One LED blinks green.
One LED blinks green.
4 Technical data
4.1 Fastening tool
Weight (empty)
Application temperature, ambient temperature
Maximum fastener length
Fastener diameter
Compression stroke
Magazine capacity in strips of 10 nails (Magazine capaci-
ty)
Maximum magnetic field strength
Frequency
4.2 Noise information and vibration values
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one fastening tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the fastening
tool. However, if the fastening tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
estimation of the level of exposure should also take into account the periods of time when the tool is not
actually in use. This may significantly reduce exposure over the total working period. Prescribe additional
safety measures to protect the operator from the effects of noise and/or vibration, such as: maintenance of
the direct fastening tool and its additional equipment or accessories, keeping the hands warm, organization
of work patterns.
Noise emission values determined in accordance with EN 15895
Emission sound pressure level at the workplace (L
Peak sound pressure level at the workplace (L
Sound (power) level (L
WA, 1s
Uncertainty (sound level)
Recoil
Energy-equivalent acceleration, for 1 mm sheet metal
onto concrete C40: (a
hw, RMS(3)
Uncertainty
5 Loading the fastening tool
5.1 Equipment required for driving nails
Nails are fed through the magazine in strip form (ready-to-use strips of nails).
*2126831*
pC, peak
)
)
2126831
Meaning
Charge status is 75 % to 100 %.
Charge status is 50 % to 75 %.
Charge status is 25 % to 50 %.
Charge status is 10 % to 25 %.
Charge status is below 10 %. The fastening tool is
ready for operation.
The fastening tool is overloaded or overheated and
thus not ready for operation.
3.9 kg
−10 ℃ ... 45 ℃
39 mm
• 2.6 mm
• 3.0 mm
20 mm
1 ... 4
−7.6 dBµA/m
13,553 MHz ... 13,567 MHz
GX 2
) 96 dB(A)
pA, 1s
) 130 dB(C)
100 dB(A)
2 dB(A) / 2 dB(C)
GX 2
3.69 m/s²
0.22 m/s²
English 21